Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Verify Router Component Failure

    Purpose

    To verify router component failure by performing a swap test on the component.

    Caution: Before performing a swap test, always check for bent pins in the midplane and check the component for stuck pins in the connector. Pins stuck in the component connector can damage other good slots during a swap test.

    Action

    Perform a swap test on a component as follows:

    1. Replace a failed component with one that you know works.
    2. Verify the component status by using the appropriate show chassis component-name command. If the replaced component works, the original component is defective.
    3. If the replaced component does not work, remove it and check the component midplane connector for bent pins. If the replaced component still does not work, contact JTAC.

    Published: 2012-08-20