Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Powering Off the SRX650 Services Gateway

 

You can use any of the following methods to power off the services gateway:

  • Issue the request system halt CLI command (recommended method). Wait until a message appears confirming that the operating system has halted. To remove power completely from the services gateway, unplug the AC power cord or DC power supply cable.

  • Press the Power button on the front of the services gateway and hold it for 4 seconds. The services gateway begins gracefully shutting down the operating system, the Services and Routing Engine (SRE) and any Gigabit-Backplane Physical Interface Modules (GPIMs), and then powers itself off. To remove power completely from the services gateway, unplug the AC power cord or DC power supply cable.

Note

Forced shutdown is not supported on the SRX650 Services Gateway.

After powering off a power supply, wait at least 60 seconds before turning it back on. After powering on a power supply, wait at least 10 seconds before turning it off.

After a power supply is turned on, it can take up to 60 seconds for status indicators—such as the POWER LED (on the front panel of the chassis) and the show chassis command display—to indicate that the power supply is functioning normally. Ignore error indicators that appear during the first 60 seconds.