Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Unpacking the SRX1400 Services Gateway

 

The SRX1400 Services Gateway is shipped in a cardboard carton. Getting Started installation instructions and an accessory box are also included in the shipping carton.

Note

The services gateway is maximally protected inside the shipping carton. Do not unpack it until you are ready to begin installation.

Figure 1 shows the SRX1400 Services Gateway in a shipping carton.

To unpack the services gateway:

  1. Move the shipping carton to a staging area as close to the installation site as possible, where you have enough room to remove the components from the chassis.
  2. Position the shipping carton with the arrows pointing up.
  3. Remove the plastic handle inserts and lift the cardboard cover off the device.
  4. Remove the foam covering the top of the services gateway.
  5. Remove the accessory box and the SRX1400 Services Gateway Getting Started Guide.
    Figure 1: Unpack the SRX1400 Services Gateway
    Unpack the SRX1400 Services
Gateway
  6. With a person on each side of the carton, carefully lift the services gateway from the carton and place it on a flat, level surface. Remove the bag covering the services gateway.
  7. Verify the parts received against the list provided in the Verifying Parts Received with the SRX1400 Services Gateway.
  8. Save the carton and the packing materials in case you need to move or ship the services gateway at a later time.Note

    At the time of shipment, the adjacent CFM slots 1 and 3 are covered with a filler cover and slot 2 is covered with a blank panel. Save the filler cover and the blank panel after removing them from the slots, in case you need them when you pack or move the chassis at a later time. The filler cover is bare metal, without a colored overlay.

  9. Proceed to install the services gateway.