Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Monitoring the SRX110 Services Gateway Components Using LEDs

 

You can monitor the chassis condition by using the LEDs. Table 1 lists the LEDs, their condition, the possible causes and corrective actions.

Table 1: Component LEDs on the Services Gateway

LED

State

Meaning

Possible Causes and Corrective Actions

Status LED

Green

Indicates that the device is functioning normally.

Normal condition. No action is required.

Amber

  • The device is starting up.

  • The Reset Config button is pressed.

Normal condition. No action is required.

Red

Indicates an error in the device.

Contact the Juniper Networks Technical Assistance Center (JTAC). See Juniper Networks Technical Assistance Center.

Alarm LED

Green

Indicates that the device is functioning normally.

Normal condition. No action is required.

Red

The device indicates a critical alarm.

A critical alarm indicates a critical situation on the gateway that requires immediate action.

See Monitoring the SRX110 Services Gateway Using Chassis Alarm Conditions.

Amber

The device indicates a major alarm.

A major alarm requires monitoring or maintenance. If left unchecked, it might cause an interruption in service or degradation in performance.

See Monitoring the SRX110 Services Gateway Using Chassis Alarm Conditions.

Off

The device is starting up.

Note: When the system is up and running, if the Alarm LED is off, it indicates that no alarms are present on the device.

Normal condition. No action is required.

Power LED

Green

The device is receiving power and is functioning normally.

Normal condition. No action is required.

Amber

The Power button has been pressed and quickly released.

Normal condition. No action is required.

Off

The device is not receiving power.

Normal condition if the services gateway is switched off. No action is required.

If you have not powered off the services gateway, verify that the AC power cord from the power source to the device is not damaged, the socket is in working condition, and the device has an AC input voltage between 110 and 240 VAC.

See Monitoring the SRX110 Services Gateway Power System.