Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Connecting the SRX210 Services Gateway to the Power Supply

 

To connect the device to the power supply:

Caution

Before connecting the device to the power supply, attach an ESD strap to an ESD point and place the other end of the strap around your bare wrist.

Note

If you are installing your services gateway on a desk, ensure that your device is adequately grounded using the grounding point on the back panel of the chassis.

  1. Plug the DC connector end of the power cable into the power connector on the back of the device (see Figure 1).
  2. Plug the AC adapter end of the power cable into an AC power outlet.
    Figure 1: Connecting the SRX210 Services Gateway to the Power Supply
    Connecting the SRX210
Services Gateway to the Power Supply
Note

The device must be connected to earth ground during normal operation. The protective earthing terminal on the rear of the chassis is provided to connect the device to ground.

Caution

We recommend using a surge protector for the power connection.

Note

Use the cable tie holder to secure the power cord on to the power supply point.

Note

We strongly recommend that you use only the 3-prong power cord supplied with your services gateway. If you are using a 2-prong power cord, then ensure that your device is adequately grounded using the grounding point available on the back panel of the chassis.