Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Replacing the Power Supply Air Filter on the SRX1400 Services Gateway

 

The SRX1400 Services Gateway power supply has one air filter located in the front of the power supply. The SRX1400 power supply air filter supports hot-swappable functionality.

Caution

Do not run the services gateway for more than a few minutes without the air filter in place.

Note

You can order an air filter kit separately. Contact your Juniper Networks customer service representative for more information. The air filter kit includes a cooling system air filter and four power supply air filters.

To replace the air filter:

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the SRX1400 chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the SRX1400 Services Gateway.

    Figure 1 shows the SRX1400 Services Gateway power supply air filter.

    Figure 1: SRX1400 Power Supply Air Filter
    SRX1400 Power Supply Air Filter

    Table 1 lists the SRX1400 services gateway power supply air filter components.

    Table 1: Power Supply Air Filter Components

    Number

    Power Supply Air Filter Components

    1

    Removable self-tap screws

    2

    Plastic holder

    3

    Air Filter

    The numbers in Figure 1 on page 10 correspond to the numbers in Table 1.

  2. Using a number-2 Phillips screwdriver, loosen the screws (removable self-tap screws, no. 3) on the power supply air filter plastic holder.
  3. Remove the plastic holder of the power supply air filter.
  4. Slide the air filter out of the plastic holder and dispose the air filter.
  5. Locate the up arrow on the replacement filter to ensure that the air filter is right side up.
  6. Slide the new air filter inside the plastic holder.
  7. Tighten the screws on the power supply air filter plastic holder, and secure it in the power supply unit.

Related Documentation