Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Powering On the AC-Powered T1600 Router

 

You can use this procedure for a router with either three-phase delta AC power supplies or three-phase wye AC power supplies. To power on the AC-powered router:

  1. Verify that the power supplies are fully inserted in the chassis and that the captive screws on their faceplates are tightened.
  2. Verify that the AC power cords are connected correctly.
  3. Verify that an external management device is connected to one of the Routing Engine ports on the CIP (AUXILIARY or CONSOLE). Note

    The management Ethernet port will not be functional until you have completed the initial configuration.

  4. Turn on the power to the external management device.
  5. Switch on the dedicated customer site circuit breakers to provide power to the AC power cables. Follow your site’s procedures.
  6. Verify that the AC OK LED on both AC power supply faceplates are lit steadily green, indicating that the power supplies are receiving power.
  7. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  8. Switch the power switch on one of the power supplies to the ON position (|). The DC OK LED blinks momentarily, then lights steadily.Note

    After a power supply is powered on, it can take up to 60 seconds for status indicators—such as the output status LEDs on the power supply, the command output, and messages on the LCD on the craft interface—to indicate that the power supply is functioning normally. Ignore error indicators that appear during the first 60 seconds.

  9. Verify that the DC OK LED on the AC power supply faceplate is lit steadily, indicating that power supply is correctly installed, functioning properly, and providing power to the DC outputs.
  10. On the external management device connected to the Routing Engine, monitor the startup process to verify that the system has booted properly.
Note

If the system is completely powered off when you power on the power supply, the Routing Engine boots as the power supply completes its startup sequence. If the Routing Engine finishes booting, you must power off the router before powering it on again. After powering on a power supply, wait at least 60 seconds before turning it off. After powering off a power supply, wait at least 60 seconds before turning it back on.