Installing the SRX110 Services Gateway on a Wall

You can install the SRX110 Services Gateway on a wall.

1. Place the device on a flat, level surface, with the Juniper Networks logo facing up. The logo is embossed on the top cover. Ensure that the rubber feet are attached to the bottom of the chassis.
2. Position a mounting bracket on each side of the chassis as shown in Figure 1.

   Figure 1: SRX110 Services Gateway Wall Installation — Attaching the Mounting Brackets

   

   Table 1 lists the parts to use to install the SRX110 Services Gateway on a wall. The numbers in Figure 1 correspond to the numbers in Table 1.

   Table 1: SRX110 Services Gateway Wall Installation Parts

   Number	Part
   1	Mounting brackets
   2	Screws (mounting bracket)

3. Use a Phillips (+) screwdriver, number 1, to install the screws that secure the mounting brackets to the chassis.
4. If you are using wall anchors to support the chassis, install two pairs of anchors on the wall.
5. Have one person grasp the sides of the device, lift it, and position it on the wall.
6. Have a second person install two pairs of mounting screws through the bracket holes on either side of the device to secure it to the wall.
7. Verify that the mounting screws on one side are aligned with the mounting screws on the opposite side and that the device is level (Figure 2).

   Figure 2: SRX110 Services Gateway Wall Installation — Attaching the Mounting Brackets