Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Installing the SRX110 Services Gateway in a Rack

 

You can front-mount the SRX110 Services Gateway in a rack. Many types of racks are acceptable, including 4-post (telco) racks, enclosed cabinets, and open-frame racks. For more information about the type of rack or cabinet that the SRX110 Services Gateway can be installed into, see SRX110 Services Gateway Rack Requirements.

Note

The rack-mounting kit is not shipped with the device and must be ordered separately.

Note
  • If you are installing multiple devices in one rack, install the first device in the lowest position in the rack and proceed upward in the rack.

  • Ensure that the rubber feet on the base of the chassis are removed for rack installation.

To install the device in a rack:

  1. Position a mounting bracket on each side of the chassis as shown in Figure 1.
    Figure 1: SRX110 Services Gateway Installation in a Rack — Positioning Mounting Brackets
    SRX110
Services Gateway Installation in a Rack — Positioning Mounting
Brackets

    Table 1 lists the parts used for installing the device on the rack. The numbers in Figure 1 correspond to the numbers in Table 1.

    Table 1: SRX Services Gateway Rack Installation Parts

    Number

    Part

    1

    Power supply adapter tray

    2

    Adapter stopper bracket

    3

    Mounting brackets

    4

    Screws (mounting bracket)

  2. Use a Phillips (+) screwdriver, number 1, to install the screws that secure the mounting brackets and power supply adapter tray to the chassis as shown in Figure 2.
    Figure 2: SRX110 Services Gateway Rack Installation — Securing Mounting Brackets and Power Supply Adapter Tray
    SRX110 Services
Gateway Rack Installation — Securing Mounting Brackets and Power
Supply Adapter Tray
  3. Place the power supply adapter in the tray as shown in Figure 3.
    Figure 3: SRX110 Services Gateway Rack Installation — Positioning Power Supply Adapter Tray
    SRX110
Services Gateway Rack Installation — Positioning Power Supply
Adapter Tray
  4. Have one person grasp the sides of the device, lift it, and position it in the rack.
  5. Align the bottom hole in each mounting bracket with a hole in each rack rail as shown in Figure 4, making sure that the chassis is level.
    Figure 4: SRX110 Services Gateway Rack Installation — Hanging the Services Gateway in a Rack
    SRX110 Services Gateway
Rack Installation — Hanging the Services Gateway in a Rack
  6. Have a second person install a mounting screw into each of the two aligned holes. Use a Phillips (+) screwdriver, number 3, to tighten the screws.
  7. Install the second screw in each mounting bracket.
  8. Verify that the mounting screws on one side of the rack are aligned with the mounting screws on the opposite side and that the device is level.