Installing the SRX100 Services Gateway on a Wall

You can install the SRX100 Services Gateway on a wall. The device is shipped with the rubber feet attached. The rubber feet help stabilize the device on the wall and enhance airflow.

To install the device on a wall:

1. Place the device on a flat and level surface with the Juniper Networks logo embossed on the top cover facing up.
2. Position a mounting bracket on each side of the chassis as shown in Figure 1.

   Figure 1: Installing the SRX100 Services Gateway on a Wall

   

3. Use a number–1 Phillips screwdriver to install the screws that secure the mounting brackets to the chassis.
4. If you are using wall anchors to support the chassis, install two pairs of anchors on the wall with mounting brackets attached.
5. Have one person grasp the sides of the device, lift it, and position it on the wall.
6. Have a second person install two pairs of mounting screws through the bracket holes on either side of the device to secure it to the wall.
7. Verify that the mounting screws on one side are aligned with the mounting screws on the opposite side and that the device is level (see Figure 2).

Figure 2: Hanging the SRX100 Services Gateway on a Wall