Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Installing the SRX100 Services Gateway in a Rack

 

You can front-mount two SRX100 Services Gateways in a rack. Many types of racks are acceptable, including four-post (telco) racks, enclosed cabinets, and open-frame racks. For more information about the type of rack or cabinet the SRX100 Services Gateway can be installed into, see SRX100 Services Gateway Rack Requirements.

Note

If you are installing multiple devices in one rack, install the lowest one first and proceed upward in the rack.

To install the device in a rack:

  1. Position the two devices in the rack-mount tray as shown in Figure 1.
    Figure 1: Installing the SRX100 Services Gateway in a Rack
    Installing the SRX100 Services
Gateway in a Rack
  2. Use a number-1 Phillips screwdriver to install the screws that secure the device to the rack-mount tray.
  3. Have one person grasp the sides of the rack-mount tray, lift it, and position it in the rack.
  4. Align the bottom hole in each side of the rack-mount tray with a hole in each rack rail as shown in Figure 2, making sure the rack-mount tray is level.
    Figure 2: Hanging the SRX100 Services Gateway in a Rack
    Hanging the SRX100 Services
Gateway in a Rack
  5. Have a second person install a mounting screw into each of the two aligned holes. Use a number-3 Phillips screwdriver to install the mounting screws.
  6. Install the second screw in each side of the rack-mount tray.
  7. Verify that the mounting screws on one side of the rack-mount tray are aligned with the mounting screws on the opposite side and that the tray is level.
Note

The rack-mounting kit is not shipped with the device and must be ordered separately.