Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Replacing Connections to MX960 Routing Engine Interface Ports

 

Replacing the Management Ethernet Cable on an MX Series Router

One Ethernet cable with RJ-45 connectors is provided with the router. To replace the cable connected to the ETHERNET port:

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Press the tab on the connector, and pull the connector straight out of the port. Figure 1 shows the connector.
  3. Disconnect the cable from the network device.
  4. Plug one end of the replacement cable into the ETHERNET port. Figure 2 shows the port.
  5. Plug the other end of the cable into the network device.
Figure 1: Cable Connector
 Cable Connector
Figure 2: Ethernet Port
Ethernet Port

Replacing the Console or Auxiliary Cable on an MX960 Router

To use a system console to configure and manage the Routing Engine, connect it to the CONSOLE port on the Routing Engine. To use a laptop, modem, or other auxiliary device, connect it to the AUX port on the Routing Engine. Both ports accept a cable with an RJ-45 connector. One RJ-45/DB-9 cable is provided with the router. If you want to connect a device to both ports, you must supply another cable.

To replace a cable connected to a management console or auxiliary device:

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Press the tab on the connector, and pull the connector straight out of the port.
  3. Disconnect the cable from the console or auxiliary device.
  4. Plug the RJ-45 end of the replacement serial cable into the CONSOLE or AUX port. Figure 3 shows the external device ports on the Routing Engine.
  5. Plug the female DB-9 end into the console or auxiliary device's serial port.
Figure 3: Auxiliary and Console Ports
Auxiliary and Console
Ports