Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Replacing an M10i Ethernet Management Cable

 

The MGMT port on the Routing Engine accepts Ethernet cable with and RJ-45 connector. For cable specifications, see Routing Engine Interface Cable and Wire Specifications for M10i Routers:

Figure 1: Routing Engine Ethernet Cable Connector
Routing Engine
Ethernet Cable Connector
Figure 2: Ethernet Management Port
Ethernet Management
Port
  1. Removing a Management Ethernet Cable

  2. Installing a Management Ethernet Cable

Removing a Management Ethernet Cable

  1. Press the tab on the connector and pull the connector straight out of the port. Figure 1 shows the connector.
  2. Disconnect the cable from the network device.

Installing a Management Ethernet Cable

  1. Plug one end of the replacement Ethernet cable into the MGMT port. Figure 2 shows the ports on the routing engine.
  2. Plug the other end of the cable into the network device.