Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?


Installing an SDRAM Module in an M10i Routing Engine


To insert a SDRAM module onto the Routing Engine (see Figure 1):

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Remove the SDRAM module from its electrostatic bag.
  3. To open the empty SDRAM slot, press the plastic ejectors on both sides.
  4. Grasp the SDRAM module by the edges, being careful not to touch any electrical components.
  5. Pressing firmly on both ends, push the module into the slot until the ejectors return completely to the closed position.
  6. Install the Routing Engine as described in Installing the M10i Routing Engine.

    You can view the SDRAM configuration and verify it was installed correctly by issuing the show chassis routing-engine command, described in Maintaining the M10i Routing Engine.

Figure 1: Installing the SDRAM Module
Installing the SDRAM