Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?


Unpacking the T320 Router


The router is shipped in a wooden crate. A wooden pallet forms the base of the crate. The router chassis is bolted to this pallet. Quick Start installation instructions and a cardboard accessory box are also included in the shipping crate.

The shipping crate measures 50 in. (127 cm) high, 30 in. (76.2 cm) wide, and 41 in. (104 cm) deep. The total weight of the crate containing the router and accessories can range from 582 lb (267 kg) to 650 lb (295 kg).


The router is maximally protected inside the shipping crate. Do not unpack it until you are ready to begin installation.

To unpack:

  1. Move the shipping crate to a staging area as close to the installation site as possible, where you have enough room to remove the components from the chassis. While the chassis is bolted to the pallet, you can use a forklift or pallet jack to move it.
  2. Position the shipping crate with the arrows pointing up.
  3. Open all the latches on the shipping crate.
  4. Remove the front door of the shipping crate cover and set it aside.
  5. Slide the remainder of the shipping crate cover off the pallet.
  6. Remove the foam covering the top of the router.
  7. Remove the accessory box and the Quick Start documentation.
  8. Verify the parts received.
  9. Remove the vapor corrosion inhibitor (VCI) packs attached to the pallet, being careful not to break the VCI packs open.
  10. To remove the brackets holding the chassis on the pallet, use a 1/2-in. socket wrench and a number 2 Phillips screwdriver to remove the bolts and screws from the brackets.
  11. Store the brackets and bolts inside the accessory box.
  12. Save the shipping crate cover, pallet, and packing materials in case you need to move or ship the router at a later time.
  13. Proceed with the installation.
    Figure 1: Contents of the Shipping Crate
    Contents of the Shipping Crate