Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Powering On an AC-Powered MX960 Router with Normal Capacity Power Supplies

 

To power on an AC-powered router:

  1. Verify that the power supplies are fully inserted in the chassis.
  2. Verify that each AC power cord is securely inserted into its appliance inlet.
  3. Verify that an external management device is connected to one of the Routing Engine ports (AUX, CONSOLE, or ETHERNET).
  4. Turn on the power to the external management device.
  5. Switch on the dedicated customer site circuit breakers. Follow the ESD and safety instructions for your site.
  6. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  7. Switch the AC switch in the chassis above each power supply to the on () position.
  8. Check that the AC power supply is correctly installed and functioning normally. Verify that the AC OK and DC OK LEDs light steadily, and the PS FAIL LED is not lit.Note

    After a power supply is powered on, it can take up to 60 seconds for status indicators—such as the status LEDs on the power supply and the show chassis command display—to indicate that the power supply is functioning normally. Ignore error indicators that appear during the first 60 seconds.

    If any of the status LEDs indicates that the power supply is not functioning normally, repeat the installation and cabling procedures.

  9. On the external management device connected to the Routing Engine, monitor the startup process to verify that the system has booted properly.Note

    If the system is completely powered off when you power on the power supply, the Routing Engine boots as the power supply completes its startup sequence. Normally, the router boots from the Junos OS on the CompactFlash card.

    After powering on a power supply, wait at least 60 seconds before turning it off.