Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Removing a JCS1200 Power Module
Figure 1 shows how to remove and install a power module.
Figure 1: Removing and Installing a JCS1200 Power Module
To remove a power module (see Figure 1):
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Open the power module handle, using one of the following
procedures:
- For a power module in one of the upper power module bays, push the inner handle release to the right; then pull the handle up to the open position.
- For a power module in one of the lower power module bays, push the inner handle release to the left; then pull the handle down to the open position.
- Use the handle to pull the power module out of the bay.
