Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Replacing an MX104 Clocking or Timing Cable
Removing an MX104 Clocking or Timing Cable
To remove a cable connected to a clocking or timing device:
- Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
- Press the tab on the connector, and pull the connector straight out of the port.
- Disconnect the cable from the network device.
Installing an MX104 Clocking or Timing Cable
To remove a cable connected to a clocking or timing device:
- Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
- Plug one end of the cable into the appropriate port.
- Plug the other end of the cable into the network device.
