Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Moving the Mounting Brackets

 

The router is shipped with the mounting brackets installed in the front-mounting position, as shown in M10i Chassis Description. If you are center-mounting the router, you must move the brackets. To move the mounting brackets (see Figure 1):

  1. Attach an ESD grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. To install the mounting brackets in the center-mounting position, you must remove the fan trays:
    1. Loosen the thumbscrew at the top of the fan tray faceplate, using a Phillips screwdriver if necessary.
    2. Grasp the handle on the faceplate and slide the tray about halfway out of the chassis.
    3. Place one hand under the fan tray to support it and slide the tray completely out of the chassis.
  3. Use a number 2 Phillips screwdriver to remove the screws securing the mounting brackets in the front-mounting position.
  4. Remove the mounting brackets by tilting the top of the mounting bracket away from the chassis and sliding it out of the slot at the bottom of the chassis.
  5. Insert the tab at the base of the mounting brackets at an angle into the slot at the bottom of the chassis in the center-mounting position (see Figure 1).
  6. Replace the screws that secure the mounting brackets to the chassis.
  7. Reinstall the fan trays:
    1. Grasp the handle on the faceplate of the fan tray with one hand and place the other hand under the unit to support it. Orient the fan tray so that the thumbscrew is at the top of the tray.
    2. Slide the tray into the slot.
    3. Tighten the thumbscrew to seat the fan tray firmly in the chassis.
Figure 1: Moving the Mounting Brackets on the Chassis
Moving the Mounting Brackets on
the Chassis