Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Replacing an M320 Management Ethernet Cable

 

To replace the management Ethernet cable:

  1. Press the tab on the connector and pull the connector straight out of the ETHERNET port. Figure 1 shows the connector.
  2. Disconnect the cable from the network device.
  3. Plug one end of the replacement cable into the appropriate ETHERNET port. The ports labeled HOST 0 connect to the Routing Engine in the upper Routing Engine slot (RE0), and the ports labeled HOST 1 connect to the Routing Engine in the lower Routing Engine slot (RE1).
  4. Plug the other end of the cable into the network device.
Figure 1: Ethernet Cable Connectors
Ethernet Cable Connectors

Related Documentation