• Download PDFs
• Installing a JCS 1200 Switch Module or Module Filler  

• Related Topics
• Preventing Electrostatic Discharge Damage to the JCS 1200 Platform
• Removing a JCS 1200 Switch Module or Module Filler
• JCS 1200 Switch Module Description

Installing a JCS 1200 Switch Module or Module Filler

Figure 1 shows how to remove and install a switch module.

Figure 1: Removing and Installing a JCS 1200 Switch Module

The JCS 1200 platform ships with one switch module . You can install a second switch module for redundancy.

To install a switch module (see Figure 1):

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
2. Remove the switch module filler, if one is installed (see Removing a JCS 1200 Switch Module or Module Filler).
3. Make sure that the release handle is in the open position.
4. Slide the switch module into the switch module interposer until it stops.
5. Push the switch module release handle to the closed position.
6. Connect the cables to the switch module.