[an error occurred while processing this directive] [an error occurred while processing this directive]

Removing a JCS 1200 Network Clock Filler

Figure 1 shows how to remove and install a network clock filler.

Figure 1: Removing and Installing a JCS 1200 Network Clock Filler

Image bb1cp043.gif

To remove a network clock filler (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Pull the release handle to the open position. The network clock filler moves out of the bay approximately 0.25 in. (0.6 cm).
  3. Slide the network clock filler out of the bay.
[an error occurred while processing this directive]