Technical Documentation

Installing a JCS 1200 Fan Pack

Figure 1 shows how to remove and install a fan pack.

Figure 1: Removing and Installing a JCS 1200 Fan Pack

Image bb1ct024.gif

To install a fan pack on a power module (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis.
  2. Make sure that the handle is rotated down so that it is parallel with the bottom of the module, with the power module rear connector facing up.
  3. Slide the fan pack into position on the power module until it stops and locks into place.
  4. Rotate the power module handle to the open position.
  5. Install the power module.