Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing the M40e Rear Upper Impeller Assembly

    To remove the rear upper impeller assembly (see Figure 1):

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to an M Series, MX Series, or T Series Router.
    2. Loosen the thumbscrew at each corner of the impeller cover, using a Phillips screwdriver if necessary.
    3. Grasp the thumbscrews at opposite corners of the impeller cover and slide the assembly halfway out of the chassis.

      Caution: To avoid injury, as you slide the assembly out of the chassis do not touch any part of the impeller behind the front panel—the impeller might still be spinning.

    4. When the impeller is no longer spinning, slide the assembly completely out of the chassis.

    Figure 1: Removing the Rear Upper Impeller Assembly

    Image g001933.gif

    Published: 2010-10-28