Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Installing the M40e Front Impeller Assembly

    To install the front impeller assembly (see Figure 1):

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to an M Series, MX Series, or T Series Router.
    2. Grasp the sides of the impeller assembly and align the rear of the assembly with the guides inside the chassis.
    3. Slide the impeller assembly all the way into the chassis.
    4. Using a Phillips screwdriver, tighten the captive screw at each corner of the craft interface.

    Figure 1: Installing the M40e Front Impeller Assembly

    Image g001917.gif

    Published: 2010-10-28