Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing the M40e Craft Interface from the Front Impeller Assembly

    If you are replacing the front impeller assembly and the replacement assembly does not have a craft interface panel on the front, you must transfer the craft interface from the removed assembly to the replacement assembly. To remove the craft interface from the removed impeller assembly:

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to an M Series, MX Series, or T Series Router.
    2. Place the removed and replacement impeller assemblies top side up on antistatic mats.
    3. If not immediately transferring the craft interface panel to the replacement assembly, place an antistatic mat or electrostatic bag on a flat, stable surface to receive it.
    4. Using a Phillips screwdriver, remove the screws from the three semicircular metal tabs on the back of the craft interface that secure it to the impeller assembly (see Figure 1). Save the screws.
    5. Grasp the ends of the craft interface, pull upward to release the hooks on the back of it from the windows on the front of the impeller assembly, then pull it toward you to free the craft interface completely (see Figure 2). If not immediately transferring it to a replacement impeller assembly, place it in the electrostatic bag or on the antistatic mat.

    Figure 1: Removing the Screws Along the Top Front Edge of the Front Impeller Assembly

    Image g001592.gif

    Figure 2: Removing the Craft Interface

    Image g001594.gif

    Published: 2010-10-28