Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Removing a Gigabit-Backplane Physical Interface Module from the SRX Series Services Gateway

 Caution

This step is applicable only for the SRX550 Services Gateway as it does not support hot-swappable functionality for GPIMs. The SRX650 Services Gateway supports hot-swappable functionality for GPIMs.

To remove a GPIM from the SRX Series Services Gateway:

Note

This procedure is applicable for the following GPIMs:

  • Single-high, single-wide GPIMs

  • Double-high, single-wide GPIMs

  • Double-high, double-wide GPIMs

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the SRX Series Services Gateway.
  2. Push the OFFLINE button to turn the GPIM offline. After the STATUS LED light turns off, it is safe to remove the GPIM. See Figure 1 and Table 1 for a description of LED indications for hot-swappable GPIM components.
    Figure 1: GPIM Example with Hot-Swappable Components
    GPIM Example with Hot-Swappable
Components

    Table 1: LED Indications for Hot-Swappable GPIM Components

    Number

    Component

    Description

    1

    STATUS LED

    The STATUS LED has the following indicator colors:

    • Green and steadily on indicates that the GPIM is functioning normally.

    • Yellow and steadily on indicates that the GPIM is starting up, running diagnostics, or going offline.

    • Red and steadily on indicates that the GPIM has failed.

    • Off indicates that the GPIM is not powered on, is offline, or is not configured.

    2

    ONLINE/OFFLINE button

    Push button to turn the GPIM offline. After the STATUS LED light goes off, it is safe to remove the GPIM from the services gateway.

  3. Label the cables connected to the GPIM so that you can later reconnect each cable to the correct GPIM.
  4. Disconnect the cables from the GPIM.
  5. If necessary, arrange the cables to prevent them from dislodging or developing stress points. Note

    If you are removing a double-high, double-wide GPIM such as the 24-Port Ethernet XPIM, you must reinstall the center GPIM slot bracket.

  6. Using a Phillips (+) screwdriver, loosen the captive screws on each side of the GPIM faceplate.
  7. Grasp the handles on each side of the GPIM faceplate, and slide the GPIM out of the services gateway.
  8. Place the GPIM in an electrostatic bag or on an antistatic mat.
  9. If you are not reinstalling a GPIM into an empty slot, install a blank GPIM faceplate over the empty slot to maintain proper airflow. If you are reinstalling another GPIM into the empty slot, see Installing a Gigabit-Backplane Physical Interface Module on the SRX Series Services Gateway.Note

    When installing a blank GPIM faceplate, make sure that the padded side of the faceplate is facing up.