Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Removing a Blank Gigabit-Backplane Physical Interface Module Faceplate from the SRX Series Services Gateway

 

To maintain proper airflow through the services gateway, leave blank faceplates in place over slots that do not contain Gigabit-Backplane Physical Interface Modules (GPIMs). Do not remove a blank faceplate unless you are immediately installing a GPIM in the empty slot.

To remove a blank faceplate:

  1. Using a Phillips (+) screwdriver, loosen the captive screws on each side of the blank faceplate.
  2. Using a flat-blade (–) screwdriver, gently pry out one side of the faceplate and pull it off.
Note

When installing a blank GPIM faceplate, make sure that the padded side of the faceplate is facing up.