Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Holding and Storing M320 FPCs

 

Holding M320 FPCs

Caution

Many components on the FPC are fragile. Failure to handle FPCs as specified in this document can cause irreparable damage.

Note

An FPC configured with PICs installed can weigh as much as An empty FPC1 or FPC2 weighs 15 lb (6.8 kg), and an empty FPC3 weighs 16 lb (7.3 kg). A fully configured FPC can weigh up to 29 lb (13.2 kg). Be prepared to accept the full weight of the FPC as you lift it.

Caution

To prevent damage when handling or carrying FPCs:

  • As you carry the FPC, do not bump it against anything. FPC components are fragile.

  • Do not grasp the FPC anywhere except places that this document indicates. In particular, never grasp the connector edge, especially at the power connector in the corner where the connector and bottom edges meet (see Figure 1).

  • Do not carry the FPC by the faceplate with only one hand (see Figure 2).

  • Do not rest any edge of an FPC directly against a hard surface (see Figure 3). If you must rest the FPC temporarily on an edge while changing its orientation between vertical and horizontal, use your hand as a cushion between the edge and the surface.

Figure 1: Do Not Grasp the Connector Edge
Do Not Grasp the
Connector Edge
Figure 2: Do Not Carry an FPC with Only One Hand
Do Not
Carry an FPC with Only One Hand
Figure 3: Do Not Rest the FPC on an Edge
Do Not Rest the
FPC on an Edge

You hold an FPC vertically when installing it into the chassis. To hold an FPC vertically (see Figure 4):

  1. Orient the FPC so that the faceplate faces you.
  2. Place one hand around the FPC faceplate about a quarter of the way down from the top edge. To avoid deforming the electromagnetic interference (EMI) shielding strip, do not press hard on it.
  3. Place your other hand at the bottom edge of the FPC. If the FPC has heat sinks about midway between the faceplate and connector edge, place your other hand against the heat sinks.
Figure 4: Holding an FPC Vertically
Holding an FPC Vertically

Storing M320 FPCs

When an FPC is not installed in a router, the FPC must be either stored in the container in which a spare FPC is shipped or stored horizontally with the component-side up on a flat, stable surface. When you store an FPC on a horizontal surface or in the shipping container, always place it inside an antistatic bag. Because the FPC is heavy and because antistatic bags are fragile, inserting the FPC into the bag is easier with two people. The storage procedures are as follows:

  • When storing an FPC with two people, one person holds the FPC in the horizontal position with the faceplate facing their body, the other person slides the opening of the bag over the FPC connector edge.

  • When storing an FPC with one person, you must insert the FPC into a bag by yourself. First lay the FPC horizontally on a flat, stable surface, component-side up. Orient the FPC with the faceplate facing you. Carefully insert the FPC connector edge into the opening of the bag, and pull the bag toward you to cover the FPC.

Caution

To prevent damage when storing FPCs:

  • Never lay an FPC component-side down.

    Figure 5: Do Not Stack FPCs
    Do Not Stack FPCs
  • Never stack an FPC under or on top of any other component (see Figure 5).