Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Upgrading to a Supported T1600 Rear Fan Tray

 
  1. Removing the RHTREARTRAY-T Rear Fan Tray

  2. Installing a Rear Fan Tray

Removing the RHTREARTRAY-T Rear Fan Tray

The rear fan tray is mounted vertically on the right side of the rear of the chassis. The rear fan tray (model number RHTREARTRAY-T) weighs about 12 lb (5.4 kg).

Caution

To maintain proper cooling, do not operate the router with the rear fan tray removed for more than 1 minute.

To remove the rear fan tray (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Loosen the captive screws on the top and bottom of the fan tray faceplate, using a Phillips (+) screwdriver, number 2.
  3. Grasp the handles and pull the fan tray halfway out of the chassis.Warning

    To avoid injury, keep tools and your fingers away from the fans as you slide the fan tray out of the chassis. The fans might still be spinning.

  4. When the fans stop spinning, grasp the handles and pull the fan tray completely out of the chassis.
Figure 1: Removing the Rear RHTREARTRAY-T Fan Tray
Removing the
Rear RHTREARTRAY-T Fan Tray

Installing a Rear Fan Tray

The rear fan tray (model number FAN-REAR-TX-T640-S) weighs about 10 pounds (4.5 kg). To install a replacement rear fan tray (see Figure 2):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Grasp the fan tray by its handles and insert it straight into the chassis.
  3. Tighten the captive screws on the fan tray faceplate to secure it in the chassis, using a Phillips (+) screwdriver, number 2.
Figure 2: Installing a Rear Fan Tray
Installing a
Rear Fan Tray