Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing a JCS1200 Fan Shuttle

    Figure 1 shows how to remove and install a fan shuttle.

    Figure 1: Removing and Installing a JCS1200 Fan Shuttle

    Removing and Installing
a JCS1200 Fan Shuttle

    To remove the fan shuttle (see Figure 1):

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    2. Power off any Routing Engines in the JCS1200 platform (see Powering Off a JCS1200 Routing Engine).
    3. If the platform is connected to a power source, disconnect the power from the platform and remove the power cables.
    4. Disconnect the cables from the modules in the rear of platform.
    5. Remove any of the following modules that are installed in the rear of the platform:
    6. Loosen the four captive thumb screws on the fan shuttle.
    7. Loosen the captive thumbscrews on the release handles, and pull the handles to the open position. The fan shuttle moves out of the chassis approximately 0.5 in. (1.3 cm).

      Caution: Use your hands to hold the frame of the fan shuttle where the fan module bays are located. Do not use the release handles to hold the fan shuttle.

    8. While you support the fan shuttle with your hands, pull the fan shuttle out of the JCS1200 chassis.

    Published: 2013-01-30