Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing a M40e DIMM Module

    The DIMM modules are located on the top of the Routing Engine. To remove a DIMM module:

    1. Place an electrostatic bag or antistatic mat on a flat, stable surface.
    2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    3. Remove the Routing Engine.
    4. Depending on which Routing Engine you are using, there are two different procedures for ejecting the DIMMs:
      • For Routing Engines with an ejector on one side of the DIMM, press the plastic ejector of the DIMM module. The edge of the module raises upward.
      • For Routing Engines with ejectors on each side of the DIMM, press the plastic ejectors on both sides of the DIMM module.
    5. Grasp the DIMM module, being careful not to touch any electrical components on the module, and firmly pull it out of the slot on the Routing Engine.
    6. Place the DIMM module on the antistatic mat or in the electrostatic bag.
    7. Push the plastic ejectors to close the empty DIMM module slot.

    Published: 2010-10-28