Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Installing a JCS1200 DC Terminal Cover

    Figure 1 shows how to remove and install a DC terminal cover.

    Figure 1: Removing and Installing a JCS1200 DC Terminal Cover

    Removing and Installing
a JCS1200 DC Terminal Cover

    To install a DC terminal cover on a JCS1200 DC platform (see Figure 1):

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    2. Make sure power has been disconnected from the platform.
    3. Turn off the power source.

      Note: After you disconnect the JCS1200 platform from power, wait at least 5 seconds before you connect the platform to power again.

    4. Orient the terminal cover so that the terminal cover fits over the DC power terminals and the screw holes on the terminal cover are aligned with the screw holes on the DC power box.
    5. Install two Phillips screws to attach the terminal cover to the power box.

    Published: 2013-01-30