Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Replacing the M20 Router Craft Interface
To remove the M20 router craft interface:
- Attach an electrostatic discharge (ESD) strap to your bare wrist, and connect the strap to one of the two ESD points on the chassis.
- Unscrew the thumbscrews on the left and right sides of the card carrier to unseat the craft interface from the midplane.
- Flip the ends of the two extractor clips, which are adjacent to the thumbscrews, toward the outside edges of the router.
- Grasp both sides of the craft interface and slide it about three-quarters of the way out of the router.
- Move one of your hands underneath the craft interface to support it, and slide the craft interface completely out of the chassis.
