Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Replacing the T4000 Alarm Relay Wires

 
  1. Removing the T4000 Alarm Relay Wires

  2. Installing the T4000 Alarm Relay Wires

Removing the T4000 Alarm Relay Wires

To remove the wires connected to an alarm-reporting device:

  1. Disconnect the existing wire at the external device.
  2. Using a 2.5-mm flat-blade screwdriver, loosen the small screws on the face of the terminal block and remove the block from the relay contact.
  3. Using the 2.5-mm flat-blade screwdriver, loosen the small screws on the side of the terminal block. Remove existing wires from the slots in the front of the block, and insert replacement wires. Tighten the screws to secure the wire.

Installing the T4000 Alarm Relay Wires

To connect replacement wires to an alarm-reporting device:

  1. Prepare the required length of replacement wire with a gauge between 28 AWG and 14 AWG (0.08 and 2.08 mm2).
  2. Plug the terminal block into the relay contact, and use a 2.5-mm flat-blade screwdriver to tighten the screws on the face of the block.
  3. Attach the other end of the wires to the external device.