Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Installing the T320 CIP

    To install the CIP (see Figure 1):

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    2. Grasp the CIP handle with one hand and hold the bottom edge of the CIP with the other hand to support its weight.

      Note: The components on the CIP are on the left side of the board, unlike the components of an FPC, which are on the right side. Verify that the components are on the left before inserting the CIP.

    3. Insert the CIP into the leftmost slot of the FPC card cage, carefully aligning the top and bottom of the CIP with the guides in the card cage.
    4. Carefully push the CIP straight into the chassis until it contacts the midplane.
    5. Tighten the screws at the top and bottom of the CIP faceplate.
    6. Reattach any external devices connected to the CIP.

      Caution: Be sure to slide the CIP straight within the slot to avoid damaging the connector pins on the front of the midplane.

    7. To verify that the CIP is installed correctly, plug an Ethernet cable into the Ethernet port on the CIP. If the host module is operational, the ACTIVE LED blinks to indicate Ethernet activity. If you can run the CLI, the CIP is installed correctly.

    Figure 1: Installing a CIP

    Installing a CIP

    Published: 2013-08-28