Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Replacing the M40e Management Ethernet Cable

    The ports on the CIP connect the Routing Engine to external management devices (see Figure 1).

    Figure 1: Routing Engine Interface Ports and Alarm Relay Contacts

    Image g001204.gif

    For cable specifications, see Routing Engine Interface Cable and Wire Specifications for the M40e Router. To replace the management Ethernet Cable:

    1. Press the tab on the connector and pull the connector straight out of the ETHERNET port. Figure 2 shows the connector.
    2. Disconnect the cable from the network device.
    3. Plug one end of the replacement cable into the appropriate ETHERNET port.Figure 1 shows the external device ports on the CIP. The ports labeled HOST 0 connect to the Routing Engine in the upper Routing Engine slot (RE 0), and the ports labeled HOST 1 connect to the Routing Engine in the lower Routing Engine slot (RE 1).
    4. Plug the other end of the cable into the network device.

    Figure 2: Ethernet Cable Connectors

    Image g003781.gif

    Published: 2010-10-28