Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing Components from a JCS1200 Chassis

    To remove components from a JCS1200 chassis:

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    2. Power off any Routing Engines in the JCS1200 platform (see Powering Off a JCS1200 Routing Engine).
    3. Disconnect the power from the platform (see Disconnecting Power from the JCS1200 Platform).
    4. Remove the following components from the front of the platform:
    5. Disengage the following components from the midplane using the procedure indicated:

      Note: Make sure each component is pulled out of the JCS1200 platform at least 1 in. (2.54 cm).

    6. Remove the fan shuttle from the platform (see Removing a JCS1200 Fan Shuttle).
    7. Remove the upper and lower power boxes from the rear of the chassis (see Removing a JCS1200 Power Box).
    8. If you are instructed to return the chassis, follow all packaging instructions and use any packaging materials for shipping that are supplied to you.

    Published: 2013-01-30