Replacing a TX Matrix Plus Console or Auxiliary Cable
Removing a Console or Auxiliary Cable
To remove a cable from the console or auxiliary port:
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Turn off the power to the console or auxiliary device.
- Pull the cable connector straight out of the port.
- Disconnect the cable from the console or auxiliary device.
Installing a Console or Auxiliary Cable
To connect to a management console or auxiliary device:
- Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
- Plug the female end of the replacement serial cable into
the appropriate
CONSOLE
orAUX
port (see Figure 1). Figure 2 shows the external device ports on the TXP-CB. - Power on the auxiliary or console device.

