Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Installing a TX Matrix LCC-CB

 

To install an LCC-CB (see Figure 1):

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
  2. Carefully align the sides of the LCC-CB with the guides inside the chassis.
  3. Slide the LCC-CB into the chassis, carefully ensuring that it is correctly aligned.
  4. Grasp both ejector handles, and press them inward to seat the LCC-CB.
  5. Tighten the captive screws on the ejector handles, using a Phillips (+) screwdriver, number 2.
  6. Reconnect any cables that were previously plugged into the ports.

  7. Verify that the LCC-CB is functioning normally:

    • Check the LEDs on the LCC-CB faceplate. The green OK LED should light steadily a few minutes after the LCC-CB is installed. If power is applied to the Routing Engine and its corresponding LCC-CB is functioning normally, the LCC-CB comes online automatically.

      If the FAIL LED is lit steadily, remove and install the LCC-CB again. If the FAIL LED still lights steadily, the LCC-CB is not functioning properly. Contact your customer support representative.

    • Use the show chassis environment cb to check the status of the LCC-CB.

Figure 1: Installing an LCC-CB
Installing an LCC-CB

Related Documentation