Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Replacing a T1600 Management Ethernet Cable

    To replace the management Ethernet cable:

    1. Press the tab on the connector and pull the connector straight out of the ETHERNET port. Figure 1 shows the connector.
    2. Disconnect the cable from the network device.
    3. Plug one end of the replacement cable into the appropriate ETHERNET port. The ports labeled HOST 0 connect to the Routing Engine in the upper Routing Engine slot (RE0), and the ports labeled HOST 1 connect to the Routing Engine in the lower Routing Engine slot (RE1).
    4. Plug the other end of the cable into the network device.

    Figure 1: Ethernet Cable Connectors

    Image g003781.gif
    Image g001507.gif

    Published: 2011-07-27