Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Removing the JCS1200 Cable Management Trays Without a Bezel

    Figure 1 shows how to remove and install the cable management trays.

    Figure 1: Removing and Installing the JCS1200 Cable Management Trays

    Removing and Installing
the JCS1200 Cable Management Trays

    The cable management trays can be removed with or without the JCS1200 bezel. If you are removing the bezel, see Removing a JCS1200 Bezel more information.

    To remove the cable management trays that are installed without the JCS1200 bezel (see Figure 1):

    1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    2. Hold the cable management tray with one hand and use a Phillips screwdriver to loosen the captured thumb screws that attach the cable management tray to the platform.
    3. Pull the cable management tray away from the platform.
    4. Repeat these steps for the other cable management tray.

    Published: 2013-01-30