Installing the Cable Management System on a QFX3008-I Interconnect Device

 

The cable management system is located at the top front of the chassis, above the card cage. The cable management system is an optional field-replaceable unit (FRU), it is not required that you install it.

Before you begin, ensure that you have the following parts and tools available to install the cable management system on a QFX3008-I Interconnect device:

  • Electrostatic discharge (ESD) grounding strap

  • Phillips (+) screwdriver, number 1

  • Eight mounting screws, size 6-32 x 3/8” (included with the cable management system)

To install the cable management system on a QFX3008-I Interconnect device (see Figure 1):

  1. Attach the ESD grounding strap to your bare wrist, and connect the strap to the ESD point on the chassis.
  2. Place the cable management system on the chassis, aligning the holes on its faceplate with the mounting holes on the chassis.
  3. Install each of the mounting screws, tightening them by turning them clockwise using the Phillips (+) screwdriver, number 1.
Figure 1: Installing the Cable Management System on a QFX3008-I Interconnect Device
Installing the
Cable Management System on a QFX3008-I Interconnect Device