Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All
     

    Related Documentation

     

    Connecting AC Power Cords to the ACX4000 Router

    To connect AC power to the router, you need the following tools:

    • ESD grounding wrist strap
    • AC power cords

    To connect AC power to the router:

    1. Locate the power cords, which should have a plug appropriate for your geographical location. See the ACX4000 AC Power Cord Specifications.
    2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to one of the ESD points on the chassis.
    3. Insert the appliance coupler end of the power cord into the appliance inlet on the power supply.
    4. Insert the power cord plug into an external AC power source receptacle.

      Note: Each power supply must be connected to a dedicated AC power feed and a dedicated customer site circuit breaker. We recommend that you use a dedicated customer site circuit breaker rated for 4.5 A (100 VAC) or 2 A (240 VAC), or as required by local code.

      Warning: The AC power supply must be connected to an external surge protector device (SPD).

    5. Dress the power cord appropriately. Verify that the power cord does not block the air exhaust and access to router components, or drape where people could trip on it.
    6. Repeat Step 1 through Step 5 for the remaining power supply.
    7. Observe the system LED on the router. If an AC power supply is functioning normally, the system LED lights green steadily.

      If the system LED is not lit, the power supply is not functioning normally. Repeat the cabling procedures.

    Figure 1: Connecting AC Power to the Router

    Connecting AC Power
to the Router
     

    Related Documentation

     

    Published: 2013-08-29