Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Attaching the AX411 Access Point to a Mounting Bracket Installed on a Wall

    To attach the AX411 Access Point to its mounting bracket:

    1. If you are installing the AX411 Access Point on a wall above a suspended ceiling, first remove the plastic cover from the access point as described in Removing the AX411 Access Point Plastic Cover.
    2. Locate the two pins protruding from the underside of the access point.
    3. Orient the access point so that the captive screw on the rear panel matches the tab on the mounting bracket.
    4. Press the access point against the mounting bracket so that the two pins go through the enlarged portions of the keyhole slots on the raised ears at each edge of the mounting bracket.
    5. Slide the access point so that the pins engage the narrower portions of the keyhole slots in the mounting bracket.
    6. Secure the access point to the mounting bracket by tightening the captive screw on the rear panel of the access point.

      Figure 1: Attaching the Access Point to the Mounting Bracket

      Image g033105.gif

    Published: 2011-07-29