Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Attaching the AX411 Access Point to a Mounting Bracket in an Overhead Enclosure
To attach the AX411 Access Point to a mounting bracket installed inside an overhead enclosure:
- Locate the two pins protruding from the underside of the access point.
- Orient the access point so that the captive screw on the rear panel matches the tab on the mounting bracket.
- Press the access point against the mounting bracket so that the two pins go through the enlarged portions of the keyhole slots on the raised ears at each edge of the mounting bracket.
- Slide the access point so that the pins engage the narrower portions of the keyhole slots in the mounting bracket.
- Secure the access point to the mounting bracket
by tightening the captive screw on the rear panel of the access point.
Figure 1: Attaching the Access Point to the Mounting Bracket
