Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Installing an AC Power Supply on the SRX650 Services Gateway

 

To install an AC power supply:

  1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see Preventing Electrostatic Discharge Damage to the SRX650 Services Gateway.
  2. Using both hands, slide the power supply straight into the chassis until the power supply is fully seated in the chassis slot. The power supply faceplate should be flush with any adjacent power supply faceplate (see Figure 1).
  3. Attach the power cord to the power supply.
  4. Route the power cord along the cable restraint toward the left or right corner of the chassis. If they are needed to hold the power cord in place, thread plastic cable ties, which you must provide, through the openings on the cable restraint.
  5. Attach the power cord to the AC power source, and switch on the dedicated facility circuit breaker for the power supply. Follow the ESD and connection instructions for your site. If the power supply is correctly installed and functioning normally, the POWER LED lights steadily.
Figure 1: Installing an AC Power Supply on the SRX650 Services Gateway
Installing an
AC Power Supply on the SRX650 Services Gateway