Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Navigation
Guide That Contains This Content
[+] Expand All
[-] Collapse All

    Basic Configuration of the 24-Port Gigabit Ethernet XPIM

    To enable the 24-Port Gigabit Ethernet XPIM installed on your SRX650 Services Gateway, you must configure its properties. You can perform the same configuration tasks using the J-Web interface or the CLI. In addition, you can configure a wider variety of options that are encountered less frequently.

    Using the J-Web Interface

    To perform basic configuration for the 24-Port Gigabit Ethernet XPIM and configure network interfaces for the services gateway with the J-Web interface:

    1. In the J-Web interface, select Configure>Interfaces.

      The Interfaces page displays and lists the network interfaces present on the services gateway. Verify whether the interface has been configured by reviewing the information in the Configured column (yes/no).

    2. Select the interface name to edit.
    3. To use the port on the XPIM, you must assign it to a security zone other than the Null zone. Optionally, you can also assign the port an IP address (for example, 192.168.3.1/24). Enter or select the following settings:
      1. Select Configure>Security>Zones.
      2. Add or select a security zone other than Null, for example, Trust.
      3. For the Host Inbound Traffic option, set the following:
        • System Services=Allow All
        • Protocols=Allow All
      4. Click OK and click Commit to apply the configuration and other pending changes (if any).
    4. To use the port on the XPIM, you must also set security policies. Select the following settings:
      1. Select Configure>Security>Policy>FW Policies.
      2. Set Policy Action: Default Policy Action=Permit-All.
      3. Click OK to save changes and click Commit to apply the configuration and other pending changes (if any).

    For advanced configuration information, see the JUNOS Network Interfaces Configuration Guide.

    Using the CLI Configuration Editor

    To perform basic configuration for the 24-Port Gigabit Ethernet XPIM and configure network interfaces for the services gateway with the CLI:

    • Verify that the 24-Port Gigabit Ethernet XPIM is installed on the services gateway:

      show chassis hardware

    • Verify the status of the interface:

      show interfaces terse

    • Assign the port an IP address:

      set interface ge-2/0/0 unit 0 family inet address Interface address/destination prefix

    • Add or select a security zone, for example, Zone1:

      set security zones security-zone zone1 interfaces ge-2/0/0.0 host-inbound-traffic system-services all

    • Add or select security zones for Host inbound traffic protocol options:

      set security zones security-zone zone1 interfaces ge-2/0/0.0 host-inbound-traffic protocols all

    • Set security policies:

      set security policies default-policy permit-all


    Published: 2010-10-21