Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

Configuring DC Power on a T1600 Router

 

After you have connected the DC power and initially configured the router, you need to configure the number of input feeds if you connected fewer than six cables to the six-input DC power supply.

For more information about configuring the DC power supply and the commands used in the procedures, see the Junos OS Administration Library.

Configuring DC Power on a T1600 Router (Five 60-A Cables on a Six-Input DC Power Supply)

When you connect five cables on a six-input DC power supply, you must specify the number of input feeds connected in the software. If the number of physical input feeds receiving power does not match the number of configured input feeds, the router displays an alarm message.

  1. Configure the number of input feeds to indicate that five DC power cables are connected.
    Note

    The default number of input feeds is 6.

  2. (Optional) Use the show statement to display the configuration to verify that it is correct.
  3. Commit the configuration to activate it on the router, and exit configuration mode.