Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 

Removing the SRE from the SRX650 Services Gateway

 

The SRE is located at the back panel of the chassis and can be installed in the horizontal slots labeled SRE0 or SRE1.0/1.1. The SRE weighs 3 lb, 13.6 oz (1.75 kg).

Caution

The SRE is not hot-swappable. You must power off the services gateway before removing or inserting an SRE.

To remove the SRE:

  1. Obtain an electrostatic bag to store the SRE after you remove it.
  2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the strap to the ESD point on the chassis.
  3. Power off the services gateway.
  4. Use a number 2 Phillips screwdriver to loosen the captive screws on each side of the SRE.
  5. Grasp the locking levers on each side of the SRE and pull toward you to unlock the SRE (see Figure 1).
  6. Slide the SRE out and place it in the electrostatic bag.
  7. If you are not replacing the SRE, install a blank panel over the empty slot.
Figure 1: Removing the Services and Routing Engine (SRE)
Removing the Services and Routing
Engine (SRE)